Kit to fit a carpet clamp to your flood restoration airmover. Will fit most snail-type airmovers. Check pictures to confirm suitability.
Please note – this is old stock, so some item may have cosmetic scratches or marks that do not affect use.
Kit contains
2 x ¼ inch Bolt
2 x Anti-vibration Nylock Nut
2 x Washer
Installation Instructions
- Centre clamp on front of blow and approximately 1 inch back from edge.
- Mark and drill two holes using the clamp holes as a template.
- Attached the carpet clamp to the blow using the supplied hardware. Put the bolts down through the clamp then blower and tighten with the washers and nuts on the inside of the blower.
Ref: PC6803 Stock Status: 8 Units in Stock
Manufactured by: Ashbys
01795 436999
